| 'Ninja
Master' Crossovers are top of the line. Our best parts; all
assembled by the head Ninja.
Features
include:
- Fully
custom build; painted masonite substrate
- Point
to point connections. No wiring in the signal path.
- All
capacitor values up to 30uF are provided by Sonicap
- Above
30uF, capacitors are provided by Erse
- Bypass
0.1 Sonicaps, when appropriate
- Alpha
Core 16ga copper foil inductors
- Mills
resistors
- Full
Onix IT-001 12ga OFC RED wire
- Heat
Shrink tubing applied to applicable connections
- Vampire
silver solder used for all connections
- 60
durometer rubber washers are provided to keep your new crossover
from vibrating against the cabinet
- SPAX
screws are supplied for easy installation
|
'Ninja
Elite' Crossovers have many of the same features as the Ninja
crossovers but we use your existing PCB and inductors.
Features
include:
- All
capacitor values up to 30uF are provided by Sonicap
- Above
30uF, capacitors are provided by Erse
- Bypass
0.1 Sonicaps,
when appropriate
- Mills
resistors
- Vampire
silver solder used for all connections
- SPAX
screws are supplied for easy installation
|
The
DIY Crossover component upgrade provides all the benefits
of the 'Ninja Master' Crossover but you build it yourself!
Features
include:
- Fully
custom build; pre-drilled and painted masonite board provided
- Schematic
provided for point to point connections. No wiring in the signal
path
- All
capacitor values up to 30uF are provided by Sonicap
- Above
30uF, capacitors are provided by Erse
- Sonicap
0.1 bypass capacitors,
when appropriate
- Alpha
Core 16ga copper foil inductors
- Mills
resistors
- Onix
IT-001 12ga OFC RED wire
- Heat
Shrink tubing provided for applicable connections
- Vampire
silver solder
- 60
durometer silicone stand-offs; keeps your new crossover from vibrating
against the cabinet
- SPAX
serrated screws for easy installation
What
is not included:
- Step
by step instruction manual (this means you need to have
a general idea of what you are doing! If you do not, go
for the professionally built Ninja version)
- Tools
required (soldering iron, wire strippers, liquid nails to
secure large inductors etc.)
- Full
wiring. This kit comes with enough wire to tie into the
existing wiring in your loudspeaker.
|
The
DIY Crossover component upgrade provides all the benefits
of the 'Ninja Elite' Crossover but you use your existing PCB
and inductors.
Features
include:
- All
capacitor values up to 30uF are provided by Sonicap
- Above
30uF, capacitors are provided by Erse
- Bypass
0.1 Sonicaps,
when appropriate
- Mills
resistors
- Vampire
silver solder used for all connections
- SPAX
screws are supplied for easy installation
What
is not included:
- Step
by step instruction manual (this means you need to have
a general idea of what you are doing! If you do not, go
for the professionally built Ninja version)
- Tools
required (soldering iron, wire strippers, liquid nails to
secure large inductors etc.)
|
