| 'Ninja
Master' Crossovers are top of the line. Our best parts; all assembled
by the head Ninja.
Features
include:
- Fully
custom build; painted masonite substrate
- Point
to point connections. No wiring in the signal path.
- All
capacitor values up to 30uF are provided by Sonicap
- Above
30uF, capacitors are provided by Erse
- When
appropriate, capacitors are bypassed by a 0.1 Sonicap
- Alpha
Core 16ga copper foil inductors
- Mills
resistors
- Full
Onix IT-001 12ga OFC RED wire
- Heat
Shrink tubing applied to applicable connections
- Vampire
silver solder used for all connections
- 60
durometer rubber washers are provided to keep your new crossover
from vibrating against the cabinet
- SPAX
screws are supplied for easy installation
|
'Ninja
Elite' Crossovers have many of the same features as the Ninja crossovers
but we use your existing PCB and inductors.
Features
include:
- All
capacitor values up to 30uF are provided by Sonicap
- Above
30uF, capacitors are provided by Erse
- When
appropriate, capacitors are bypassed by a 0.1 Sonicap
- Mills
resistors
- Vampire
silver solder used for all connections
- SPAX
screws are supplied for easy installation
|
The
DIY 'Ninja Master' Crossover component upgrade provides all the
benefits of the 'Ninja Master' Crossovers but you build it yourself!
Features
include:
- Ppre-drilled
and painted masonite board provided
- Schematic
provided for point to point connections. No wiring in the signal
path.
- All
capacitor values up to 30uF are provided by Sonicap
- Above
30uF, capacitors are provided by Erse
- When
appropriate,
capacitors are bypassed by a 0.1 Sonicap
- Alpha
Core 16ga copper foil inductors
- Mills
resistors
- Onix
IT-001 12ga OFC RED wire for connections to drivers/binding posts
- Heat
Shrink tubing provided for applicable connections
- Vampire
silver solder provided
- 60
durometer rubber washers are provided to keep your new crossover
from vibrating against the cabinet
- SPAX
screws are supplied for easy installation
What
is not included:
- Step
by step instruction manual (this means you need to have a general
idea of what you are doing! If you do not, go for the professionally
built Ninja version)
- Tools
required (soldering iron, wire strippers, liquid nails to secure
large inductors etc.)
|
The
DIY 'Ninja Elite' Crossover component upgrade provides all the benefits
of the 'Ninja Elite' Crossovers but you use your exsisting PCB and
inductors and build it yourself!
Features
include:
- All
capacitor values up to 30uF are provided by Sonicap
- Above
30uF, capacitors are provided by Erse
- When
appropriate, capacitors are bypassed by a 0.1 Sonicap
- Mills
resistors
- Vampire
silver solder used for all connections
- SPAX
screws are supplied for easy installation
What
is not included:
- Step
by step instruction manual (this means you need to have a general
idea of what you are doing! If you do not, go for the professionally
built Ninja version)
- Tools
required (soldering iron, wire strippers, liquid nails to secure
large inductors etc.)
|
